top of page

AN54LV-P15

Chip : 

nRF54L15

PCB ANTENNA, .OPEN MCU

Antenna : 

* Nordic nRF54L15 SoC Solution
* A recommended 3rd-party module by Nordic Semiconductor.
* Intended for Bluetooth specification BT6
* Intended for FCC, IC, CE, Telec (MIC), KC, SRRC, NCC, RCM, WPC
* Intended for Cyber Security Standard EN18031
* 128 MHz ARM® Cortex™ processor with TrustZone® technology
* 1.5MB Flash Memory / 256KB RAM
* Dimension: 6.4 x 8.4 x 1.5 mm (0.25 x 0.33 x 0.05 inches)
* 32 GPIO
* PCB Antenna
* Interfaces: QSPI, SPI, UART, I2C, I2S,PDM, PWM, ADC, and NFC
* Operating temperature: -40 to +105°C
* Highly flexible multiprotocol SoC ideally suited for Bluetooth® Low Energy, ANT+, Zigbee, Thread (802.15.4), Matter, Amazon Sidewalk ultra low-power wireless applications.

Raytac's AN54LV-P15 is a BT 6.0 stack (Bluetooth low energy or BLE) module designed based on Nordic nRF54L15 SoC solution, which incorporates: GPIO, QSPI, SPI, UART, I2C, I2S, PDM, PWM, ADC and NFC interfaces for connecting peripherals and sensors.

Features

  • Dual Transmission mode of BLE & 2.4GHz RF upon customer's preference.

  • Compact size with (L) 8.4 x (W) 6.4 x (H) 1.5mm

  • Low power requirements, ultra-low peak, average and idle mode power consumption.

  • Supports Bluetooth 6.0, IEEE 802.15.4 & 2.4Ghz RF & ANT & upon customer's preference.

  • Pre-Certified Module: FCC / IC / CE / Telec / KC / SRRC / NCC / WPC Certified & CE RED / RCM Compliant.

  • Highly flexible multiprotocol SoC ideally suited for Bluetooth® Low Energy and 2.4GHz ultra-low-power wireless applications.

Quick Specifications

  • 128 MHz ARM® Cortex™ processor with TrustZone® technology

  • Supply: 1.7V – 3.6V

  • Flexible and configurable 32 GPIOs

  • Bluetooth 6.0, IEEE 802.15.4-2020, and 2.4 GHz transceiver

        •  -96dBm sensitivity in 1Mbps Bluetooth low energy (BLE) mode

        •  -104 dBm sensitivity in 125 kbps Bluetooth Low Energy mode (long range) with a 0.1% bit error rate

        •  -102 dBm typical sensitivity in IEEE 802.15.4

        •  Up to +8 dBm TX power; 1 dB step size from -8 dBm to +8 dBm

        •  RSSI (1dB resolution)

  • Supported data rates:

    •  Bluetooth 6.0: 2Mbps, 1 Mbps, 500 kbps, 125 kbps

    •  IEEE 802.15.4-2020: 250 kbps

    •  Proprietary 2.4 GHz: 4 Mbps, 2 Mbps, 1 Mbps

    •  Advanced on-chip interfaces        

        •  RISC-V Coprocessor

        •  Global RTC (GRTC) that can run in System OFF mode and implement a shared system timer

        •  Seven 32-bit timers with counter mode

        •  Up to five fully featured serial interfaces with EasyDMA, supporting I2C, SPI controller/peripheral, and UART

        •  One high-speed SPIM up to 32 MHz, four up to 8 MHz

        •  One high-speed UARTE up to 4 Mbps, four up to 1 Mbps

        •  I2C up to 400 kHz

        •  Three pulse width modulator (PWM) units with EasyDMA

        •  I2S two channel Inter-IC sound interface

        •  ADC with up to eight programmable gain channels. 14-bit at 31.25 ksps, 12-bit at 250 ksps, and up to 10-bit at 2 Msps

        •  Pulse density modulation (PDM) interface

        •  Near field communication (NFC)

        •  Up to two quadrature decoders (QDEC)

        •  Comparator and low-power comparator with wake-up from System OFF mode

        •  Temperature sensor

  • Operating Temp: -40°C to +105°C

  • Platform security

        •  Secure/non-secure memory protection

        •  Symmetric and asymmetric key crypto accelerator

        •  ecure key management

        •  Tamper detection

        •  Immutable boot partition

        •  Debug access port protection

        •  Two watchdog timers for secure and non-secure access


Datasheet


Design Guide

  • Footprint (compatible for Protel, Altium Design)

  • 2D/3D drawing

bottom of page